⎝⎛大家玩棋牌⎞⎠

Hailing Magnetic Powder Brake >> Tension Control System >> ZC-3 Tension Sensor

Tension control system

Complete dynamometer system

Magnetic powder brake

Magnetic powder clutch

Photoelectric correction system

Magnetic particle

ZC-3 tension sensor

Overview
ZC-3 tension sensor is an instrument used to measure the tension value of the coil during tension control.
用途 1.Use
This sensor is a special sensor for tension test. It is composed of constant tension automatic controller, magnetic powder brake and magnetic powder clutch to form a tension control system to realize tension control. It is widely used in the control systems of six-color gravure printing presses, slitters, and dry-rewinders.
工作原理及结构特点 2. Working principle and structural characteristics
The sensor adopts the resistance strain measurement principle, and the S-beam structure is used to ensure the test accuracy requirements and the ability to resist lateral swing is enhanced.
3.Parameter description

model
ZC-100
ZC-150
ZC-200
ZC-300
ZC-500
Rated load:
100N
150N
200N
300N
500N
Insulation resistance:
≥2000 megaohm (100V test)
Non-linear:
0.1% FS
Input resistance:
≥350 ohm
Lag:
0.1% FS
Output resistance:
350 ± 1 ohm
repeat:
0.1% FS
Sensor supply bridge voltage:
6-12VDC
Dimensions:
See dimensions
Power consumption:
≤0.4w
weight:
1.8kg
Zero position:
≤1% FS
Aviation socket model:
X14K4P
Sensitivity:
2MV / V
Aviation plug model:
X14J4A
Use environment:
Do not use in severely corrosive environments

4, use
1) According to the installation requirements, the sensor is integrated with the shaft shoulder and the bearing seat roller. The center of the shoulder should correspond to the center point of the upper plate. When mounting the bearing on the upper plate of the sensor, pay attention that the thickness of the upper plate does not exceed the thickness of the upper plate after tightening the screws (13)
2) Electrical connection socket according to 1 power + 4 power ground 2 signal + 3 signal ground or red, blue, yellow, green.
3) During installation, do not drop hard objects such as pins into the gap between the indenter and the upper cover to avoid affecting the performance.
4) The parameters of each connection part of the sensor have been strictly tested after adjustment. Do not disassemble or change the original installation state at will.
Note: It is based on the ZC-3 sensor, which can increase the transmitter part, which can output 4-20mA; 0-5VDC; 0-10VDC; the signal wiring method is as shown above.


Installation attention points:
1: The screws for installing the tension detector and the bearing seat must not be too long. If it is too long, the reed of the tension detector cannot work normally and the tension cannot be detected.
2: When using the side for fixing, please pay attention that the fixing screw should not be too long, otherwise the measuring mechanism in the tension detector will be damaged.
3: The tension sensor must not be subjected to strong impact or vibration at any time, otherwise the tension detector will be damaged.

斗牛平台 韦德足球 欢乐拼三张 欢乐拼三张